Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ragerix
New Contributor
‎04-12-2024 01:36 PM

AdTran 900e iniatial set up through ethernet port not working

Hello we are trying to set up one an Adtran device. It is reset to factory.  When we try to connect through the Ethernet port and follow the direction 10.10.10.1 is not being recognized. Any advice? I order a CRAFT port cable and will try that approach next.

 

thanks

 

 

Labels (2)
Labels
0 Kudos
Reply
1 Reply
BMullar
New Contributor III
‎04-24-2024 05:47 PM

Re: AdTran 900e iniatial set up through ethernet port not working

RAGERIX,

Per the Total Access 900 Series (3rd Generation) document (61213908F1-13A) the unit comes with a default IP address of 10.10.10.1.

You can factory default the unit using "erase startup-config".  Per the document "The device will have a blank configuration upon reboot."  Also "Upon reboot, you will have to reconfigure the unit using the port labeled CRAFT." which lead you to believe that the default IP address of 10.10.10.1 is deleted and you have to use the serial CRAFT port to access the CLI and reprogram the management IP.

Hope this helps.

 

Regards,

BMULLAR

0 Kudos
Accept as Solution Reply