cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Configuring the ATLAS Video Module for use with a KIV-7

Configuring the ATLAS Video Module for use with a KIV-7

pastedImage_0.png

The ATLAS products with the Video Module are “Layer 1” devices used to provide a WAN link for video codec systems along with the KIV-7 or other secure/encrypted systems. This is the recommended configuration for the ATLAS Video Module:

System Config

          Primary Timing Source = T1/PRI     Slt:0  Port:1 Sys Ctrl  (This should be the port with PRI connection to the Telephone company)

Modules

          Video

                Menu

                     Configuration    

                          Name = Video Port (can be changed to indicate the end equipment if desired)                   

                          Clock +/- = Normal    

                          Data = Normal    

                          CTS = Follow DCD

                          DCD = Normal

                          DSR = Normal

                          DTR = Ignore DTR Ans

           Imux

                Menu

                     Configuration

                          TXINIT Timer (sec)                       20

                          TXFA Timer (sec)                        20

                          TXADD01 Timer (sec)                  100

                          TXDEQ Timer (sec)                     100

                          TANULL Timer (sec)                    20

                          TCID Timer (sec)                         10

                          Call Stagger                                500 ms        

Dial Plan

          Network Term

              Slot/Service = 0)Sys Cntrl (Slot holding the module that is connecting to the telephone company PRI)

              Port/PEP = 1) T1/PRI (Port connecting to the telephone company PRI)

              Signaling = PRI    

              Out#Accept = $  (wild card allowing any number, any length of digits to be dialed)

              Out#Reject = [+] (should be empty)

              Ifce Config = [+]  (this will have the PRI configuration including the PRI switch type and channels to be used)

          User Term

              Slot/Service = 1) VIDEO (this is the slot where the video module is installed)

              Port/PEP = 1) VIDEO  (this is the port on the video module the Codec is connected to)

              Sig = (this will be blank because there is no signaling selection for the video module)

              In#Accept = [555-1111] (this should be the phone number for your location)

              To the right of the "Accept Number" there will be a column that says "Treat Call As"

              Set this for “PRI Video” if only 1 number is used in the bonding negotiation.

              Out#Reject = [+] (typically left empty)

              Ifce Config

              Dialing Method = RS-366

              RS-366 Type = Type III

              Dial After = 20 sec or EON

              Default Call Type = 64k

              Default Dial Call As = Digital

              Source ID = 0

              Default Min DS0's = 2

              Default Max DS0's = 6

              Min Incoming DS0's = 2

              Max Incoming DS0's = 6

*This would be the setup to allow a 384kbps call.

Labels (2)
Version history
Revision #:
1 of 1
Last update:
‎02-26-2013 07:27 AM
Updated by:
 
Contributors