cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Contributor III
Contributor III

BSAP 3.2.0-HC Has Been Released

BSAP 3.2.0-HC has been released to hotfix a reboot associated with Dynamic Multicast Operation. You can avoid this reboot by updating your AP firmware to 3.2.0-HC. 3.2.0-HC firmware should only be used with 3.2.0-X vWLAN Software.

For help upgrading, please use Upgrading BlueSocket vWLAN Controllers and Access Points​.

For information around version 3.2.0, please see the BSAP and vWLAN 3.2.0 Release Notes.​ The software pages on ADTRAN's website are linked below.

Software Downloads
vWLAN (Appliance or Virtual Appliance)
BSAP 1920/1925

BSAP 1930/1935/1940

BSAP 2020
BSAP 2030/2035/2135
BSAP 3040/3045
0 Kudos
Reply
5 Replies
Highlighted
New Contributor

Re: BSAP 3.2.0-HC Has Been Released

Hi! I can not find where I can download the HC update. Where do I find it?

0 Kudos
Reply
Highlighted
Contributor II
Contributor II

Re: BSAP 3.2.0-HC Has Been Released

lschaedle the downloads are located in the table above, you will need a account to download them.

Am I correct to assume that 3.2.0-HC can be used on vWLAN platform Version 3.2.0.HA Build 650478 or should it be installed on 3.2-0HC only?

0 Kudos
Reply
Highlighted
New Contributor

Re: BSAP 3.2.0-HC Has Been Released

Your vWLAN upgrade instructions need to be updated in light of the new 3.1 and 3.2 versions including the AP firmware in the image.  The old instructions last modified in 2017 no longer track with these new versions.

0 Kudos
Reply
Highlighted
New Contributor

Re: BSAP 3.2.0-HC Has Been Released

Additonally, if anyone uses Bradford/Fortinet Network Sentry integration, please be advised of the following issue with the Network Sentry and vWLAN version 3.2.0HB:

(From Fortinet support)

"The API data from the controller has changed in the newer firmware version. FortiNAC is looking for the WAP ip addresses by looking for data returned in the <ipaddr> field. We no longer see the <ipaddr> field in the API response. We are seeing the <public-ip> and <private-ip> fields returned. Our proposed change would be to use the data returned in <public-ip>."

They have offered to create a patch for this issue but have not done so yet.  I image that now that they are aware of it, they will integrate it into future releases.

0 Kudos
Reply
Highlighted
New Contributor

Re: BSAP 3.2.0-HC Has Been Released

Fortinet addressed this in version 8.5.

0 Kudos
Reply