cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
New Contributor II

How do I upload and install factory default config file on a NetVanta 1238

Jump to solution

I have downloaded the factory default config file (default-config-123x.cfg) from the Support section. I performed a factory reset using CLI but still cannot access the GUI following all the instructions step by step. I have made numerous attempts at activating the GUI with instructions from this site as well as many I found doing Google searches.  Most of the line commands return an error message stating command is unrecognized. Every command from "no ip firewall" to "end" fails as unrecognized.

  • Switch>enable
  • Switch#configure terminal
  • Switch (config)#ip http server
  • Switch (config)#username admin password password
  • Switch (config)#no ip firewall
  • Switch (config)#int eth 0/1
  • Switch (config-intf-eth 0/1)#ip address 10.10.10.1 255.0.0.0
  • Switch (config-intf-eth 0/1))#no shut
  • Switch (config-intf-eth 0/1))#end
  • Switch (config)#exit
  • Switch#write

I would greatly appreciate a step-by-step that works or a link to same that will show me how to upload and install the factory default config using the CLI.

0 Kudos
Reply
1 Solution

Accepted Solutions
Highlighted
New Contributor II

Re: How do I upload and install factory default config file on a NetVanta 1238

Jump to solution
0 Kudos
Reply
3 Replies
Highlighted
New Contributor II

Re: How do I upload and install factory default config file on a NetVanta 1238

Jump to solution

I neglected to mention this is a GEN 1 device.

0 Kudos
Reply
Highlighted
New Contributor II

Re: How do I upload and install factory default config file on a NetVanta 1238

Jump to solution
0 Kudos
Reply
Highlighted
New Contributor

Re: How do I upload and install factory default config file on a NetVanta 1238

Jump to solution

How were you able to solve this issue?

0 Kudos
Reply