New NV1531P switch out of the box, booting it up with no POE devices connected, we get error "POWER_OVER_ETHERNET Failed to reset PoE controller! Error code:-3" constantly (new event comes up every 15 seconds). We have rebooted the switch multiple times and tried firmware v13.2.2 and v11.2.0, same issue.
We are going to swap it for another new NV1531P at this point but I'm wondering if this is just a bad POE module or something others have seen.
NV1531P#sh power inline
Total Power: 65.0W
Total Power Used: 0.0W
Total Power Available: 65.0W
Average Total Power Used: 0.000W
For a new device to be powered, there must be at least 19W available power.
To power a Class 4 device, there must be at least 30W available power.
'Limited' status is only valid for PoE+ devices that negotiate power using LLDP.
It is indicated when the requested power of the PD is not met.
Interface Admin Status Power Class
(Watts)
----------------------------------------------------------------------------------
giga-swx 0/1 auto Searching 0.000 N/A
giga-swx 0/2 auto Searching 0.000 N/A
giga-swx 0/3 auto Searching 0.000 N/A
giga-swx 0/4 auto Searching 0.000 N/A
giga-swx 0/5 auto Searching 0.000 N/A
giga-swx 0/6 auto Searching 0.000 N/A
giga-swx 0/7 auto Searching 0.000 N/A
giga-swx 0/8 auto Searching 0.000 N/A
2019.01.09 10:37:11 POWER_OVER_ETHERNET Failed to reset PoE controller! Error code:-3
