Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
furatxp
New Contributor
‎01-20-2017 12:06 AM

Red stat after update

I had issue with duplex mismatches on NetVanta 1534P 2.1 when I set the port to 1000Mbps some port work OK and some don't, so I update the firmware to (N1534v2A-R12-2-0) from the GUI then after I reboot I got STAT red light on and everything stop working, can someone help me plz? Thanks

0 Kudos
Reply
1 Reply
jayh
Honored Contributor
Honored Contributor
‎01-20-2017 10:07 AM

Re: Red stat after update

It's failing the initial boot setup. Could be a "boot system" command not referencing the current firmware, or a corrupt file upload, or something else. You'll need to console in to see what is going on.

Attach a terminal to the console port (9600,N,8,1) and power-cycle the switch. You should see a series of messages appear as the switch (attempts to) boot up. Paste the output into a message here.

Accept as Solution Reply