Config for NetVanta 3448

[chipper9]

Hello all,

I'm not at all familiar with this router and need some help.

I simply need to set the router up to route between to networks.

WAN side (int eth0/1) with IP x.x.x.x 255.255.255.252

LAN network of x.x.x.x 255.255.255.248, statically assigned (no DHCP).

I would prefer to use any of the switch ports (1-8) for my static LAN devices.

Also would prefer to use NAT.

Can anyone help me out with the proper CLI prompts?

Thanks in advance,

[Anonymous · Accepted solution]

:

Thank you for asking this question in the support community.  There are several ways you can configure the AOS device to meet the requirements you have stated.  Here is a sample configuration that you can paste into the CLI at the "(config)#" prompt:

interface eth 0/1

  description Public Internet Connection

  ip address 1.1.1.1 255.255.255.252

  ip access-policy Public

  no shutdown

  no lldp send-and-receive

!

interface vlan 1

  description LAN

  ip address  10.1.1.1  255.255.255.0

  ip access-policy Private

  no shutdown

!

ip route 0.0.0.0 0.0.0.0 <default-gateway to ISP address>

!

ip access-list standard wizard-ics

  remark Internet NAT

  permit any

!

ip policy-class Public

!

ip policy-class Private

  allow list self self

  nat source list wizard-ics interface eth 0/1 overload

Also, the Accessing the Web Interface (GUI) in AOS or the Video may be beneficial for your implementation.  From the GUI you can follow the Configuring Internet Access (Many to one NAT) with the Firewall Wizard in AOS video to assist you with setting up Internet access and NAT using the built in wizard.

I hope that makes sense, but please do not hesitate to reply to this post with any additional questions or information.  I will be happy to help in any way I can.

Levi

[chipper9]

Thanks Levi.