Let me elaborate on that a little. If you have a matching pool (same network and subnet), then that would present a problem. I’m not sure what scenario would require that though. Ideally, only have pools for the network you want to provide DHCP on.
An example would be that you have two networks (VLAN 1 and VLAN 2). You want to provide DHCP for VLAN 2, but relay for VLAN 1. Only maintain dhcp pool for that network on the router.
ip dhcp pool voice
Network 192.168.2.0 255.255.255.0
dns-server 184.108.40.206 220.127.116.11
Interface vlan 1
description Data LAN
ip address 192.168.1.1 255.255.255.0
ip dhcp relay destination 192.168.1.100 (address of DHCP server)
Interface vlan 2
Description Voice LAN
ip address 192.168.2.1 255.255.255.0
No, thank you very much. I understood exactly what you were saying. We have a DATA vlan and a VOICE vlan. We want to continue to have the voice gateway (DHCP pool and SVI) on the router but we want to take the DATA DHCP off of that router (remove the pool) and relay it to a different location. Based on what I had tried before, it seemed to be impossible on an Adtran, but it looks like it's doable according to this new command (which I didn't know about). I'm going to test this out today... I hope the AOS I'm using supports it. Your example above fits my situation perfectly. I understand everything else about the configuration, I just didn't know that command existed.
I’ve used this setting a lot in installations I do. Usually, my customer has a DHCP server on their network, but I want to control DHCP for my voice installation. I configure the Adtran router or switch to provide DHCP for the voice, and relay for the data network. Works pretty well.