cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
New Contributor III

FXO Failover Configuration

Jump to solution

Does anyone have an example FXO failover configuration for the NetVanta 6000 Series gateways? I had configured this a couple of years ago from some documents that were on the old kb.adtran.com site and I can't seem to find those same documents again. I am running transparent proxy on a NV 6334 with Polycom phones registering to our Class 5 softswitch. I am wanting to provide POTS survivability for 911, etc. in the event the phones lose connectivity to the softswitch.

0 Kudos
Reply
1 Solution

Accepted Solutions
Highlighted
New Contributor III

Re: FXO Failover Configuration

Jump to solution

David,

Thanks for the follow up, I ended up opening a service request on this and was able to get it setup and working. Below are some of the key commands that helped...

voice trunk T01 type analog supervision loop-start

  description "FAILOVER"

  connect fxo 0/1

  rtp delay-mode adaptive

  codec-list Default

voice grouped-trunk FAILOVER

  description "FAILOVER"

  trunk T01

  accept 911 cost 0

  permit proxy

voip name-service host sbc.xyx.com sip udp

ip sip proxy emergency-call-routing proxy

ip sip proxy emergency-call-routing accept 911

domain-proxy failover

View solution in original post

0 Kudos
Reply
2 Replies
Highlighted
Valued Contributor
Valued Contributor

Re: FXO Failover Configuration

Jump to solution

Cwallace,

Thanks for posting!  The SIP Proxy Survivability feature is built in and works just by configuring a separate voice trunk on the unit.  Assuming all of your SIP proxy configuration is complete, below is an example of adding an FXO trunk.

voice trunk T10 type analog supervision loop-start

  blind-dial

  connect fxo 0/0

!

voice grouped-trunk ANALOG

  description "911 and survivability"

  trunk T10

  accept $ cost 0

!

ip sip proxy emergency-call-routing accept 911


The last command shown is optional.  This command forces all 911 calls to always use the FXO port.  Also, the FXO port numbering, 0/0 is shown, may be different depending upon which unit, module slot, and specific port you are using.  Feel free to respond to this post if you have further questions.


Thanks!

David


Highlighted
New Contributor III

Re: FXO Failover Configuration

Jump to solution

David,

Thanks for the follow up, I ended up opening a service request on this and was able to get it setup and working. Below are some of the key commands that helped...

voice trunk T01 type analog supervision loop-start

  description "FAILOVER"

  connect fxo 0/1

  rtp delay-mode adaptive

  codec-list Default

voice grouped-trunk FAILOVER

  description "FAILOVER"

  trunk T01

  accept 911 cost 0

  permit proxy

voip name-service host sbc.xyx.com sip udp

ip sip proxy emergency-call-routing proxy

ip sip proxy emergency-call-routing accept 911

domain-proxy failover

View solution in original post

0 Kudos
Reply