rawli
New Contributor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-03-2013
04:12 PM
1 Solution
Accepted Solutions


Honored Contributor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
10-04-2013
12:11 PM
From the command line:
enable
[enter password]
config t
interface pri 1
no shutdown
[Ctrl-Z]
write memory
From the GUI:
Physical Interfaces on left-hand menu
Locate the E1 physical interface in the list.
Click on pri 1 under its logical interface column.
Check the Enabled box.
Click the Save button.
1 Reply


Honored Contributor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
10-04-2013
12:11 PM
From the command line:
enable
[enter password]
config t
interface pri 1
no shutdown
[Ctrl-Z]
write memory
From the GUI:
Physical Interfaces on left-hand menu
Locate the E1 physical interface in the list.
Click on pri 1 under its logical interface column.
Check the Enabled box.
Click the Save button.