cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
dcorrea
Contributor
Contributor

NV7100 FXO Disconnect Time

Jump to solution

     Hello Guys,

I have a problem with my FXO lines on the NV7100 when the system receives a call, it works fine but sometimes if a second call arrives the line seems to be off-hook like it wasn't disconnected from the first call.

I think is a disconnection time parameter. is it possible to modify this!?

Thanks,

Tags (3)
0 Kudos
1 Solution

Accepted Solutions
most_ahdy
Contributor
Contributor

Re: NV7100 FXO Disconnect Time

Jump to solution

Yes, you can ,

Kindly find the attached file that I hope it will help you.

Thanks,

Mostafa Aly

View solution in original post

0 Kudos
7 Replies
most_ahdy
Contributor
Contributor

Re: NV7100 FXO Disconnect Time

Jump to solution

Yes, you can ,

Kindly find the attached file that I hope it will help you.

Thanks,

Mostafa Aly

View solution in original post

0 Kudos
dcorrea
Contributor
Contributor

Re: NV7100 FXO Disconnect Time

Jump to solution

Dear most,

That was right, the loop-disconnect was the problem. Now it's solved.

Thanks for the file,

ing_gomez_clevermx
New Contributor III

Re: NV7100 FXO Disconnect Time

Jump to solution

I hve the same problem, and i cannot solve the problem, can you tell mi if there is more parameters that i should change?

Thanks

merbac
New Contributor III

Re: NV7100 FXO Disconnect Time

Jump to solution

ScreenHunter_168 May. 14 15.37.jpgGetting this unrecognized command when I try to configure.

most_ahdy
Contributor
Contributor

Re: NV7100 FXO Disconnect Time

Jump to solution

This command is not supported in older version of AOS, I can not remember the first version that support this command, you can make a search and you will find it.

and if your AOS can not support this command you can make an upgrade to newer version "check your hardware revision first to see if it support the newer version of AOS".

Kindly send your results.

Thanks,

Mostafa Aly

Anonymous
Not applicable

Re: NV7100 FXO Disconnect Time

Jump to solution

merbac

The loop-disconnect configuration command was added in AOS release A5.01. 

Thanks

Charles

merbac
New Contributor III

Re: NV7100 FXO Disconnect Time

Jump to solution

Oh by the way Charles, thank you!