cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
randy007
New Contributor

Adtran 904 need 48v analog fxs

The analog ports off the Adtran 904 seem to be much less than 48V and therefore don't power a Linear device needed for our Intercom system.  Is there a way to set them to 48V?

0 Kudos
2 Replies
Anonymous
Not applicable

Re: Adtran 904 need 48v analog fxs

Are you testing the voltage at the port on the adtran or at the end of the cable pair and what voltage are you reading? If you already are testing directly at the adtran, is this low voltage consistent across all FXS ports on the device?

If it's an issue getting the intercom system to answer the call, then the ring voltage can be adjusted on the physical FXO port page of the adtran. We've encountered issues where paging systems expect 70~90v minimum to answer, and although the ring voltage tops out at 70v that fixed it for us.

jayh
Honored Contributor
Honored Contributor

Re: Adtran 904 need 48v analog fxs

The on-hook voltage is indeed -48 volts. If you're measuring it with the unit off-hook it will be substantially less. This is normal on all analog telephone circuits.