Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
dfreeman7
New Contributor
‎11-02-2020 09:42 AM

Adtran total access 908e gen 3 PRI to Avaya MM710

Our carrier has installed two Pri's:

t1: esf framing
linecode: b8zs
PRI protocol: NI-2

Should be simple enough however I cant get my circuits to come up. I've installed several PRI's in the past but don't recall ever using a Adtran in place of the carrier's normal smart jack.

I'm assuming I'd use a T1 cross over cable.

Anything different about these 900e boxes I need to know ?

Thanks, Dan

 

 

 

0 Kudos
Reply
1 Reply
jranderson
New Contributor
‎11-11-2020 08:46 AM

Re: Adtran total access 908e gen 3 PRI to Avaya MM710

May not need the crossover, i'd try a straight through to see if it comes up.

0 Kudos
Accept as Solution Reply