BIG NEWS! The Adtran Support Community is moving! In the next few weeks it will be housed in a new location. Be sure to visit our NEW Adtran Community before the end of July to check it out and verify that you can access all the resources and features that you need. If you discover any issues with your account or access, or just want to let us know about your experience, be sure to use our Feedback Form to let us know!
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
tedllewellyn
New Contributor II

TA900e ethernet mtu

Jump to solution

Is there a way to set the MTU on the Ethernet interfaces on a 3rd Gen TA900e? I'm using firmware version 11 code. I've been looking in the CLI for interface commands and global commands but I don't see anything. It allows for setting speed and duplex but I don't see MTU, unless it's buried deeper in the hierarchy somewhere.

I'm not trying to solve a particular issue. I need to account for all of the settings when we interface to another device. I'm not sure that this fits into any of the categories they've set up for this device, so I'm categorizing this for admin & management.

Labels (1)
Tags (1)
0 Kudos
1 Solution

Accepted Solutions
tedllewellyn
New Contributor II

Re: TA900e ethernet mtu

Jump to solution

OK, so I found the MTU setting, but "show run verbose" doesn't display anything. Anyone know what the default MTU is on a 3rd Gen TA900e?

View solution in original post

0 Kudos
1 Reply
tedllewellyn
New Contributor II

Re: TA900e ethernet mtu

Jump to solution

OK, so I found the MTU setting, but "show run verbose" doesn't display anything. Anyone know what the default MTU is on a 3rd Gen TA900e?

0 Kudos