Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
drjarmon
New Contributor III
‎06-25-2015 04:34 PM

How change n-command polling script?

Getting checksum mismatch warnings.  It was determined that the command show file /start-config checksum needs to be show file startup-config checksum.  Where do you change this in n-command?

AdtranNMS polling script needs to be updated:

  1. 2015.06.03 18:32:00 SSH:0> terminal length 0
  2. 2015.06.03 18:32:00 SSH:0> ena
  3. 2015.06.03 18:32:00 OPERATING_SYSTEM.SESSION User management ENABLE OK on portal SSH 0
  4. 2015.06.03 18:32:01 SSH:0> terminal length 0
  5. 2015.06.03 18:32:01 SSH:0> no events
  6. 2015.06.03 18:32:01 SSH:0> show cflash
  7. 2015.06.03 18:32:01 SSH:0> show version
  8. 2015.06.03 18:32:02 SSH:0> write memory
  9. 2015.06.03 18:32:03 SSH:0> show dynvoice-config checksum       ! Removed this command
  10. 2015.06.03 18:32:04 SSH:0> show running-config checksum
  11. 2015.06.03 18:32:05 SSH:0> show file /startup-config checksum  ! Change to: show startup-config checksum
  12. 2015.06.03 18:32:05 SSH:0> show flash exception-report*

Thanks

0 Kudos
Reply