Using n-command MSP to push files to devices

[bpm]

Hi all,

Is it possible to push files to devices (e.g. NV7100) other than firmware files?  I would like to push push down prompts etc. using MSP.  Is this possible?

[Anonymous · Accepted solution]

@bpm - You can push configuration changes to AOS devices being monitored by MSP, as well as load new configuration files. The "Push Configuration" option allows a cut and paste of configuration changes to be pushed to the device. These changes should be pasted as though the device is at the '(config)#' prompt. A new configuration can be loaded by selecting the "Install Config" option which is located by "double-clicking" on the device that you want to upload the config on.

More information can be found in the guide below:

Introduction to n-Command MSP

Let us know if you have any further questions.

Thanks,

Noor

[Anonymous]

- I went ahead and flagged this post as “Assumed Answered.”  If any of the responses on this thread assisted you, please mark them as either Correct or Helpful answers with the applicable buttons.  This will make them visible and help other members of the community find solutions more easily.  If you still need assistance, I would be more than happy to continue working with you on this - just let me know in a reply.

Thanks,

Noor

[Anonymous]

:

I went ahead and flagged the "Correct Answer" on this post to make it more visible and help other members of the community find solutions more easily. If you don't feel like the answer I marked was correct, feel free to come back to this post and unmark it and select another in its place with the applicable buttons.  If you still need assistance, we would be more than happy to continue working with you on this - just let us know in a reply.

Thanks,

Levi