cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
smillstid
New Contributor

DSP Failure

Jump to solution

I have an Adtran 904 2nd Gen.  Getting DSP message below.  Can this be corrected?

Current system image file is "T900G2A-R10-5-3-E.biz"

VoIP DSP 0 Initialize.

Loading Starcore DSP Image from Compressed File.

  Boot version: G2.R10.5.3

  Application Version: G2.R10.5.3

  Starting DSP.

  Booting.

  Memory Test.

  Failed to load application

DSP is not runningInitializing Analog Services.......

0 Kudos
1 Solution

Accepted Solutions
jayh
Honored Contributor
Honored Contributor

Re: DSP Failure

Jump to solution

In the rare cases where we've seen this, it has been a hardware failure requiring RMA of the unit.  You'll probably need to open a support case. 

Gotta love that long Adtran warranty! 

View solution in original post

0 Kudos
6 Replies
jayh
Honored Contributor
Honored Contributor

Re: DSP Failure

Jump to solution

In the rare cases where we've seen this, it has been a hardware failure requiring RMA of the unit.  You'll probably need to open a support case. 

Gotta love that long Adtran warranty! 

0 Kudos

Re: DSP Failure

Jump to solution

Not the answer I was hoping for but appreciate the quick response.

Anonymous
Not applicable

Re: DSP Failure

Jump to solution

Smillstid,

I'm going to mark Jayh's answer above as correct, since this is likely the issue.  If you need to setup an RMA with Adtran, please call 888-423-8726 to open a support ticket.

Thanks!

David

sen-se
New Contributor

Re: DSP Failure

Jump to solution

Does anyone know where I can get the following firmware for an adtran 924 2nd gen.

T900G2A-R10-9-M-27-E.biz

Anonymous
Not applicable

Re: DSP Failure

Jump to solution

Sen-se,

R10.9.M.27 is not a GA release of firmware. The next maintenance release of firmware that will contain fixes from R10.9.M.27 will be R10.9.2, which is scheduled to be available on January 3rd.

Thanks,

David

cmaroon
New Contributor

Re: DSP Failure

Jump to solution

FOund the same issue after I upgraded from R7 to 13.12.1. 

 

VoIP DSP 0 Initialize.
Loading Starcore DSP Image from Compressed File.
Boot version: G2.R10.8.M.4b
Application Version: G2.R10.8.M.4b
Starting DSP.
Booting.
Memory Test.
DSP memory test failed.

Failed to load application

DSP is not runningInitializing Analog Services.......
SNMP Agent: Starting: Success!
FTP server: Starting service on first mounted drive.
cli: starting user interface
Persistence viewer: Restoring from startup-config..