Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable
‎03-23-2020 02:39 PM

Block inbound number

Is it possible to block an inbound number (CID) in the Adtran 550? Thank you!

0 Kudos
Reply
1 Reply
Anonymous
Not applicable
‎03-23-2020 03:23 PM

Re: Block inbound number

Not really.

If the telco connection is a PRI and the connection to your end equipment is also PRI, you can set it to "Swap ANI/DNIS" so that when the call comes from the Telco, the ATLAS will swap ANI and DNIS, and then route the call based on the ANI, You can configure any port to accept the unwanted ANI. Then the rest of the calls can go out the USER TERM PRI, and you can "Swap ANI/DNIS" again so that the correct DNIS is sent to the end equipment... Of course when doing this, if there is no ANI, then the call won't be routed anywhere and will fail.

Good Luck,

Patrick

0 Kudos
Accept as Solution Reply