Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable
‎02-18-2015 09:57 AM

Remove a network from the Atlas 550

I have a PRI connection to a Cisco device on my Atlas 550 that is no longer needed. I don't want to remove the card since the other port is in use but would prefer to disable this port, otherwise I have an ALARM all the time. How do I disable this port?

0 Kudos
Reply
1 Reply
Anonymous
Not applicable
‎02-18-2015 10:29 AM

Re: Remove a network from the Atlas 550

You can "disable" the port by removing its configuration from either the DIAL PLAN or the DEDICATED MAPS (whichever location you have it configured). Once it is removed from the DED MAP or DIAL PLAN, the front panel alarm should clear. You will still see the alarm if you go under MODULES and look at the ALARM STATUS for the module, where you can see all the ports, but the module status shouldn't show an alarm.

Hope that makes sense,
Patrick

0 Kudos
Accept as Solution Reply