cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
qqblog
New Contributor

no dial tone

Jump to solution

altas 830 base unit + octal fxs.

the fxs ports are connected to fax card which sends large volume of fax 7x24 without interruptions.

fax card -> octal fxs -> PRI

our server detects no dial tone for many many calls.

pls advise what settings are required.

Tags (3)
0 Kudos
1 Solution

Accepted Solutions
Anonymous
Not applicable

Re: no dial tone

Jump to solution

If the FXS ports are configured in the DIAL PLAN then they are able to provide dial tone. There is no configuration to enable or disable this.

It is possible your fax server demand is greater than the DSP resources of the ATLAS. The ATLAS 830 has 27 DSP resources. DSP resources are used to generate dial tone, generate ring back, generate digits to be propagated out of the unit, and to receive digits.

If you have an FXS module in all 8 slots, then that is 64 FXS ports. You can only get dial tone on 27 at a time. It is possible to have more than 27 calls up at once, but you can only get dial tone, ring back, etc. on 27 at a time.

There is a "Forward Disconnect" setting under the DIAL PLAN, USER TERM, in the IFCE CONFIG. This cuts the loop current for a specified period of milliseconds when the far end hangs up. Generally this should be set when connected to fax machines/servers. The default is "Disabled" but can be set to 600, 1000, or 2000 ms. Obviously the fax server would have to wait this period of time before placing an outbound call if the far end terminated the previous call.

If specific ports consistently do not get dial tone, then you should check those ports with a phone or butt set.

Hope this helps,

Patrick

View solution in original post

0 Kudos
3 Replies
Anonymous
Not applicable

Re: no dial tone

Jump to solution

If the FXS ports are configured in the DIAL PLAN then they are able to provide dial tone. There is no configuration to enable or disable this.

It is possible your fax server demand is greater than the DSP resources of the ATLAS. The ATLAS 830 has 27 DSP resources. DSP resources are used to generate dial tone, generate ring back, generate digits to be propagated out of the unit, and to receive digits.

If you have an FXS module in all 8 slots, then that is 64 FXS ports. You can only get dial tone on 27 at a time. It is possible to have more than 27 calls up at once, but you can only get dial tone, ring back, etc. on 27 at a time.

There is a "Forward Disconnect" setting under the DIAL PLAN, USER TERM, in the IFCE CONFIG. This cuts the loop current for a specified period of milliseconds when the far end hangs up. Generally this should be set when connected to fax machines/servers. The default is "Disabled" but can be set to 600, 1000, or 2000 ms. Obviously the fax server would have to wait this period of time before placing an outbound call if the far end terminated the previous call.

If specific ports consistently do not get dial tone, then you should check those ports with a phone or butt set.

Hope this helps,

Patrick

0 Kudos
Anonymous
Not applicable

Re: no dial tone

Jump to solution

We haven't had any additional updates on this question so I am going to mark it as "assumed answered". If you need further assistance let us know.

qqblog
New Contributor

Re: no dial tone

Jump to solution

forward disconnect = disable. this helps no dial tone. but i have another problem. a few lines (random) could not hang up properly occasionally.