
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cant Access the GUI on a 1238P
Switch was defaulted. I consoled in and set up IP address/Subnet. I enabled the HTTP server and created username and password. I can ping it, but cant get to the login page. I have tried Firefox, Safari, and IE. I have tried on a Mac and a PC as well. Any ideas?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Accept as Solution
- Report Inappropriate Content
Re: Cant Access the GUI on a 1238P
Here's my http configuration from a 1638. And don't forget to set a default gateway:
ip route 0.0.0.0 0.0.0.0 10.101.0.1
!
http authentication LoginUseRadius
http server
http session-timeout 14400
http secure-server
Can you access the box any way other than console? Telnet, SSH?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Accept as Solution
- Report Inappropriate Content
Re: Cant Access the GUI on a 1238P
For the GUI to be accessible you have to turn it on, setup the IP, and have a Username/Password setup. You can create one from enable prompt:
1) configure terminal
2) username * password *

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Accept as Solution
- Report Inappropriate Content
Re: Cant Access the GUI on a 1238P
I have enabled it, set ip address, added username and password. I have not defined a default route. I have done this several times, but dontt remember setting up a default route for the switches in order to access the GUI. I will give that a shot.
Have not tried to access it other than console and GUI

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Accept as Solution
- Report Inappropriate Content
Re: Cant Access the GUI on a 1238P
If you are still having issues can add the show run of the device? Also where are you trying to access the device from--is the computer hookup directly to that switch?