Cant Access the GUI on a 1238P

[tylerdurden]

Switch was defaulted.  I consoled in and set up IP address/Subnet.  I enabled the HTTP server and created username and password.  I can ping it, but cant get to the login page.  I have tried Firefox, Safari, and IE.  I have tried on a Mac and a PC as well.  Any ideas?

[diggly]

Here's my http configuration from a 1638.  And don't forget to set a default gateway:

ip route 0.0.0.0 0.0.0.0 10.101.0.1

!

http authentication LoginUseRadius

http server

http session-timeout 14400

http secure-server

Can you access the box any way other than console?   Telnet, SSH?

[Anonymous]

For the GUI to be accessible you have to turn it on, setup the IP, and have a Username/Password setup. You can create one from enable prompt:

1) configure terminal

2) username * password *

[tylerdurden]

I have enabled it, set ip address, added username and password.  I have not defined a default route.  I have done this several times, but dontt remember setting up a default route for the switches in order to access the GUI.  I will give that a shot.

Have not tried to access it other than console and GUI

[Anonymous]

If you are still having issues can add the show run of the device? Also where are you trying to access the device from--is the computer hookup directly to that switch?