BIG NEWS! The Adtran Support Community is moving! In the next few weeks it will be housed in a new location. Be sure to visit our NEW Adtran Community before the end of July to check it out and verify that you can access all the resources and features that you need. If you discover any issues with your account or access, or just want to let us know about your experience, be sure to use our Feedback Form to let us know!
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
peddlefaster
New Contributor

Netvanta 1234 enabling new vlan

Jump to solution

I have a simple configuration where I needed to create a new vlan 100 for IP phones. When vlan 100 was created it automatically configured the interface in shutdown. When I try to enable or no shutdown vlan 100 the switch does a shutdown on all other vlans. What am I missing this seems simple. I basically have vlan 1 and 100 and I need them both enabled.

Labels (1)
0 Kudos
1 Solution

Accepted Solutions
Anonymous
Not applicable

Re: Netvanta 1234 enabling new vlan

Jump to solution

You may have multiple vlans on a layer 2 switch but only one active (not shutdown) vlan interface on a switch. 

View solution in original post

0 Kudos
5 Replies

Re: Netvanta 1234 enabling new vlan

Jump to solution

Is this problem because I created vlan interfaces for both vlans and assigned IP addresses for each. The IP addresses are in different subnets such as vlan 100 10.10.40.x/24 & vlan 1 192.168.4.x/24. Am I only allowed to create vlan 100 and place ports into it, but avoid creating an interface vlan 100 with an IP address?

Anonymous
Not applicable

Re: Netvanta 1234 enabling new vlan

Jump to solution

You may have multiple vlans on a layer 2 switch but only one active (not shutdown) vlan interface on a switch. 

0 Kudos

Re: Netvanta 1234 enabling new vlan

Jump to solution

To be sure I understand then I can create multiple vlans on this switch and route between them external, but only 1 of these vlans can be associated with an interface and IP address.

Anonymous
Not applicable

Re: Netvanta 1234 enabling new vlan

Jump to solution

You are correct.  As you may already know, you will need to use a vlan trunk switchport which is connected to the layer 3 device which is configured with subinterfaces with vlan tagging.  this will enable you to correctly route all vlans.

Anonymous
Not applicable

Re: Netvanta 1234 enabling new vlan

Jump to solution