Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
rao
New Contributor
‎11-09-2017 10:04 AM

tacacs+ authorization commands not working for L2 or L3 switches. Works fine for routers

We are trying to restrict access to L2 and L3 switches for our Tier I group in tacacs+.

Command set works for routers but not switches. Please advice.

0 Kudos
Reply
2 Replies
jayh
Honored Contributor
Honored Contributor
‎11-09-2017 12:06 PM

Re: tacacs+ authorization commands not working for L2 or L3 switches. Works fine for routers

Lots more information needed, I've had no issues with TACACS+ on Adtran switches.

Can you post model and firmware as well as config with passwords redacted? What is the nature of the failure?

What are the results of "debug tacacs+" when you attempt to authenticate?

0 Kudos
Accept as Solution Reply
rao
New Contributor
‎11-16-2017 11:06 AM

Re: tacacs+ authorization commands not working for L2 or L3 switches. Works fine for routers

Jay,

Thank you for the reply.

I don't see any issues with the Authentication, but the issue could be authorization limiting with access levels.

(ADTRAN has only two access levels 1 & 7 (=15))

I had allowed given full access, same time want to limit access using command sets, which is not working.

0 Kudos
Accept as Solution Reply