Adtran
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
rao
New Contributor
‎11-09-2017 10:04 AM

tacacs+ authorization commands not working for L2 or L3 switches. Works fine for routers

We are trying to restrict access to L2 and L3 switches for our Tier I group in tacacs+.

Command set works for routers but not switches. Please advice.

0 Kudos
Reply
2 Replies
jayh
Honored Contributor
Honored Contributor
‎11-09-2017 12:06 PM

Re: tacacs+ authorization commands not working for L2 or L3 switches. Works fine for routers

Lots more information needed, I've had no issues with TACACS+ on Adtran switches.

Can you post model and firmware as well as config with passwords redacted? What is the nature of the failure?

What are the results of "debug tacacs+" when you attempt to authenticate?

0 Kudos
Accept as Solution Reply
rao
New Contributor
‎11-16-2017 11:06 AM

Re: tacacs+ authorization commands not working for L2 or L3 switches. Works fine for routers

Jay,

Thank you for the reply.

I don't see any issues with the Authentication, but the issue could be authorization limiting with access levels.

(ADTRAN has only two access levels 1 & 7 (=15))

I had allowed given full access, same time want to limit access using command sets, which is not working.

0 Kudos
Accept as Solution Reply