Trying to get BGP established on the 1544. I can get the Dell switch to see the Adtran in show ip bgp sum, but the Adtran does not see the Dell when performing a show bgp ipv4 sum. They are also not exchanging routes. I'm about to hit up the manual and see if I missed something but figured I'd shoot you a message in case there was a command unique to setting up BGP on an Adtran. Two devices are pingable, but the Dell switch and Adtran are on different VLANs.
Here's my BGP config on the Adtran
router bgp 65002
bgp router-id 1.1.1.2
neighbor 55.55.55.1
description BestISPEver
remote-as 65001
no shutdown
exit
address-family ipv4
network 22.22.22.0 mask 255.255.255.248
network 33.33.33.0 mask 255.255.255.128
network 55.55.55.0 mask 255.255.255.252
exit
!
!
!
!
ip route 22.22.22.0 255.255.255.248 null 0
ip route 33.33.33.0 255.255.255.128 null 0
ip route 55.55.55.0 255.255.255.252 null 0
!
interface vlan 4030
ip address 55.55.55.2 255.255.255.252
ip route-cache express
no shutdown
interface gigabit-switchport 0/24
description UPLINK_TO_ISP
no shutdown
switchport access vlan 4030
Switch#show bgp ipv4 sum
BGP router identifier 1.1.1.2, local AS number 65002
3 network entries, 3 paths, and 1 BGP path attribute entries
Neighbor V AS MsgRcvd MsgSent InQ OutQ Up/Down State/PfxRcd
On the Dell you see that BGP is established, just no route sharing:
Redistributing:
Source Metric Dist List Route Map
--------- ---------- -------------------------------- --------------------------------
Neighbor ASN MsgRcvd MsgSent State Up/Down Time Pfx Rcvd
---------------- ----- -------- -------- ------------- -------------- ---------
55.55.55.2 65002 468 515 ACTIVE 0:00:27:17 0
