Adtran
Help
BIG NEWS! The Adtran Support Community is moving! In the next few weeks it will be housed in a new location. Be sure to visit our NEW Adtran Community before the end of July to check it out and verify that you can access all the resources and features that you need. If you discover any issues with your account or access, or just want to let us know about your experience, be sure to use our Feedback Form to let us know!
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
gwa60060
New Contributor
‎02-01-2016 03:39 PM

How can a port be made a member of multiple VLANS

The GUI only lets me assign a single VLAN or all (Trunk). I need several VLANs but not all of them on one port.

Thanks!

0 Kudos
Reply
2 Replies
Anonymous
Not applicable
‎02-02-2016 08:46 AM

Re: How can a port be made a member of multiple VLANS

You can allow specific VLANs by selecting the switchport in the GUI . Go to Data>Switch>Ports and then select the switchport that is configured as a Trunk (membership Trunk). This will bring up another window where you will be able to configure the specific VLANs that you want for that Trunk.

Accept as Solution Reply
gwa60060
New Contributor
‎02-02-2016 11:05 AM

Re: How can a port be made a member of multiple VLANS

Donna,

Thanks you for the detailed answer - I found the stated menu and then was able to see the cli  config after changes made in the gui. This is my first experience with Adtran and it's going to take a little getting used to.

Thanks again!

0 Kudos
Accept as Solution Reply