cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
New Contributor

Netvanta 1534 second gen not getting firmware from xmodem

I am trying to test a Netvanta Switch for work. It boots straight into bootstrap mode and does not detect any files on the device. I tried following a guide on a similar post to use xmodem to transfer the firmware onto the device, however I have had no luck getting it to work. I am using tera terms. the unit sn: LBADTN1703AC877. would it be possible to assign an ip to the device through bootstrap then do a tftp transfer? or is xmodem the only way? any help would be greatly appreciated.

0 Kudos
Reply
1 Reply
Highlighted
New Contributor

Re: Netvanta 1534 second gen not getting firmware from xmodem

Try this, I'm not sure if it will work on a 1534, but it might. It does for most AOS devices.

Configure your host computer with a static IP in a private subnet, for example 192.168.1.20 mask 255.255.255.0

Connect a cable from your computer to the first ethernet port on the device.

Also access the device on the console.

At the bootstrap# prompt type: ip address 192.168.1.1 255.255.255.0

Test if you can ping 192.168.1.1 from your host computer.

If so, set your host as a TFTP server with the appropriate image in the /tftpboot directory.

From the serial console window type: copy tftp flash

Follow the prompts with the IP address of your computer and the filename.

0 Kudos