cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
childebrecht
New Contributor

Voice and Data VLAN Config AOS to ASE system

Good morning.  I have been trying to convert an Adtran AOS config over to an Adtran ASE config without much luck.  It is a fairly basic setup.  I have a data vlan(default vlan 1) and voice vlan configured on each port for providing SIP phone service with a passthru option.  I then uplink to a secondary switch to give me more available ports.  This config has worked fine on the AOS operating system but I do not think I am utilizing the correct commands/config on the ASE switch.  I have attached an example of my AOS configs that I am looking to transition to ASE.  Any assistance would be appreciated.  I have attached my 2 AOS config files.  on AdtranAOS_scrubbed.txt file switchport 0/1 is my incoming voice traffic, switchport 0/47 is my incoming LAN traffic and switchport 0/48 is my uplink to 2nd switch.  on Adtran_2nd switch_scrubbed.txt switchport 0/24 is my uplink from 1st switch.

Thank you  for any assistance you can provide.

0 Kudos
2 Replies
daniel_ogles
New Contributor

Re: Voice and Data VLAN Config AOS to ASE system

childebrecht,

The syntax is somewhat different for ASE (ADTRAN Switch Engine) and requires you to define the voice VLAN a bit differently. Take a look at Configuring Layer 2 Services in ASEhttps://supportcommunity.adtran.com/t5/ASE/Configuring-Layer-2-Services-in-ASE/ta-p/33691 specifically starting with "Configuring the Voice VLAN Using the CLI" starting on page 64. This may help you get what you need for this setup. If not, then you may consider opening a ticket with our Product Support team via this link: https://portal.adtran.com/web/page/portal/Adtran/wp_support_openasupportcase.

olywrestle
New Contributor II

Re: Voice and Data VLAN Config AOS to ASE system