Net Vantra 3130, Need to support Annex M

[tomcross]

We are setting up a small WAN for one of our customers,

They are passing data between each other, at the moment they cannot afford Sync connections so we opted for Annex M.

We now find that the NV3130 do not support Annex M.

Is there going to be a firmware update to incorporate this very soon? I Hope.

Tom

[Anonymous]

:

Thank you for asking this question in the support community.  I noticed you also opened a ticket with ADTRAN Technical Support.  When you get a resolution, will you post the results on the forum so other users can benefit?

Levi

[tomcross]

Hi all.

Seems the Annex M activation was left off the GUI.

It can be activated via the CLI.

Telnet to the unit:

At the ">" prompt type "enable" and hit enter.

Enter your password.

Now at the "#" prompt type "config t" and hit enter.

Type "interface adsl 0/1" and hit enter.

Type "training-mode ADSL2_ANNEX-M" and hit enter.

That's it.

Tom

[tomcross · Accepted solution]

Sorry for Previous Post there is an error.

This is correct.

Worked on 2 units

Instructions to Force Adtran 3130 to Annex M

Telnet to the unit:

At the ">" prompt type "enable" and hit enter.

Enter your password.

Now at the "#" prompt type "config t" and hit enter.

Type "interface adsl 0/1" and hit enter.

Type "training-mode adsl2+annex-m" and hit enter.

type Exit.

You will be asked to issue command to save config changes.

Type "wri" press enter

To check config.

Type "show config" press enter.