The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
mikeatcomtech
New Contributor

SIP rate-pacing Commands on 3120

Jump to solution

I recently tried to issue the following commands on a 3120:

ip sip proxy register rate-adaption server-expires 1800

ip sip proxy register rate-adaption user-expires 90

I am unable to find them in the command list in the 3120, are these commands only available on a router with the SBC pack?

Labels (2)
Tags (3)
0 Kudos
1 Solution

Accepted Solutions
Anonymous
Not applicable

Re: SIP rate-pacing Commands on 3120

Jump to solution

- Thanks for posting your question on the forum.

The command should be available on non-SBC code as well. It was introduced in A5.02 but was modified in R10.8 to remove the keyword "ip" from the command.

What firmware are you running? Try removing the keyword "ip"and seeing if it will take it then.

If you are still having issues, please reply to this post with the firmware you are running and a screenshot of what you are seeing.

Thanks,

Noor

View solution in original post

0 Kudos
2 Replies
Anonymous
Not applicable

Re: SIP rate-pacing Commands on 3120

Jump to solution

- Thanks for posting your question on the forum.

The command should be available on non-SBC code as well. It was introduced in A5.02 but was modified in R10.8 to remove the keyword "ip" from the command.

What firmware are you running? Try removing the keyword "ip"and seeing if it will take it then.

If you are still having issues, please reply to this post with the firmware you are running and a screenshot of what you are seeing.

Thanks,

Noor

0 Kudos

Re: SIP rate-pacing Commands on 3120

Jump to solution

Noor,

I was on Ver 18 fimware.  I upgraded to R10.9.4 and I am now able to enter the commands.  Thank you!