Configure ADSL Dialer via ppp - without ADSL NIM

[cmcu]

Hello,

We are trying to use a bridged static DSL connection for DR testing.

I have done this successfully on a Cisco 1841 using nothing more than a virtual Dialer interface linked to an onboard ethernet interface.

Trying to learn how similar might be accomplished on a NetVanta 3430. The router is at the latest version of the enhanced feature pack, vR11.3.0.E.

It seems like there are a large # of PPPoE subcommands under the Cisco's ethernet interface. These are lacking on the Adtran side.

Please advise... thanks!

[Anonymous · Accepted solution]

cmcu - Thanks for posting your question on the forum!

Yes, this configuration can be done but it looks a little different than the Cisco configuration. Essentially, you will need to configure the PPP interface with the authentication and IP address information and then cross-connect this to the ethernet interface. You may find the following guide helpful: Configuring Ethernet Broadband Internet Access in AOS Integrated Switch_Router Products

This guide refers to integrated switch/router products but Option C on page 6 will apply to you. You will simply substitute VLAN interface for ETH interface instead and there won't be a need to map the VLAN interface to a port.

Please do not hesitate to let us know if you have any questions.

Thanks,

Noor

[Anonymous]

cmcu:

I went ahead and flagged the "Correct Answer" on this post to make it more visible and help other members of the community find solutions more easily. If you don't feel like the answer I marked was correct, feel free to come back to this post to unmark it and select another in its place with the applicable buttons.  If you have any additional information on this that others may benefit from, please come back to this post to provide an update.  If you still need assistance, we would be more than happy to continue working with you on this - just let us know in a reply.

Thanks,

Levi