cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
New Contributor

Using N-Command to push firmware, then reboot.

Hi All,

So I was using N-Command to advise an Adtran to update the Firmware, then reboot.. Instead, N-Command told the 6355 to reboot first (The primary image was removed due to space issue so the Adtran went into bootstrap).

My question is that in N-Command, how can I advise it to push firmware first, then reboot second.

I hope this makes sense.

Labels (1)
Tags (1)
0 Kudos
Reply
2 Replies
Highlighted
New Contributor

Re: Using N-Command to push firmware, then reboot.

Do you have a screen shot of how you setup the job in N-command? If you used the correct order for the tasks in the job, it shouldn't have rebooted first.

0 Kudos
Reply
Highlighted
New Contributor

Re: Using N-Command to push firmware, then reboot.

Sorry about the delay, I've attached a screenshot.2018-07-11 08_22_56-Adtran nCommandMSP-8.3.3 (11_23_15 14_19 CST) - Mozilla Firefo - __Remote.png

0 Kudos
Reply