
bradh8148
New Contributor III
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-28-2014
03:07 PM
I am evaluating the Netvanta 6310. When I connect two 8 port FXS VIMs and try to boot up the Adtran it becomes unresponsive once it says "initializing Analog Services for FXS 1/1-8".
However if I disconnect one of the FXS VIMs it boots up normally. I have tried both FXS VIMS in both slots separately. I am able to get the Adtran to boot successfully when only one VIM is installed into either slot.
So I know there is no issue with Slot 1 or 2 and that there is no issue with either FXS VIM card. Is there any thing I need to configure to get both FXS VIMS to work at the same time?
1 Solution
Accepted Solutions

bradh8148
New Contributor III
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
10-29-2014
03:18 PM
Updating the Firmware to the current version resolved this issue.
1 Reply

bradh8148
New Contributor III
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
10-29-2014
03:18 PM
Updating the Firmware to the current version resolved this issue.