cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
bradh8148
New Contributor III

can the Netvanta 6310 support two 8 port FXS VIMs?

Jump to solution

I am evaluating the Netvanta 6310. When I connect two 8 port FXS VIMs and try to boot up the Adtran it becomes unresponsive once it says "initializing Analog Services for FXS 1/1-8".

However if I disconnect one of the FXS VIMs it boots up normally. I have tried both FXS VIMS in both slots separately. I am able to get the Adtran to boot successfully when only one VIM is installed into either slot.

So I know there is no issue with Slot 1 or 2 and that there is no issue with either FXS VIM card. Is there any thing I need to configure to get both FXS VIMS to work at the same time?

Labels (1)
0 Kudos
1 Solution

Accepted Solutions
bradh8148
New Contributor III

Re: can the Netvanta 6310 support two 8 port FXS VIMs?

Jump to solution

Updating the Firmware to the current version resolved this issue.

View solution in original post

0 Kudos
1 Reply
bradh8148
New Contributor III

Re: can the Netvanta 6310 support two 8 port FXS VIMs?

Jump to solution

Updating the Firmware to the current version resolved this issue.

View solution in original post

0 Kudos