- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a Netvanta 7100 connected to a PRI. Getting the "must dial a 1 or zero when dialing this number" when placing long distance calls. It looks like it is stripping the 1 when placing the call.
Local and internal calls work fine, setup for 7 digit dialing.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
I found a work-around for this - DNIS substitution 1NXXNXXXXXX ---> 11NXXNXXXXXX
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
I found a work-around for this - DNIS substitution 1NXXNXXXXXX ---> 11NXXNXXXXXX

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Accept as Solution
- Report Inappropriate Content
Re: No Long Distance - PRI (Stripping 1?)
I actually found, likely the true correct answer.
Adtran ships the box with ISDN Number Templates applied. You can access the page from the webui Voice->ISDN Num Templates In there it states:
ISDN Number Templates look similar to standard dial plan templates but are used exclusively by ISDN-based trunks to recognize dialed numbers as a particular type of call. Additionally, if a prefix is specified, then the number template matches against that prefix as well but strips those digits before sending the number. |
There is a default template in there for National calling with a Prefix of 1 and then NXX-NXX-XXXX. According to this Num Template rule the 1 is stripped from the message sent out the PRI when you have a dnis of 1-NXX-NXX-XXXX
Then best thing is to delete this rule from the webui or from the CLI with the following command:
no isdn-number-template 6 prefix 1 national NXX-NXX-XXXX