cannot receive inbound calls over a SIP trunk but outbound works

[renaultl]

Hello Matt i am new in the forum, i have a problem with my sip trunk provider, i am able to place a call, but not able to received a call, to be able to have the sip trunk up  i have to put in the sip identity the username  and password and not the DID provided i think is is the problem.  your opinion?

i have a dump of the sip debug if you want.

Thantk

[Anonymous]

renaultl,

I branched this to a new discussion thread. Can you gather the output from a debug voice verbose and a debug sip stack messages both enabled at the same time for a failed outbound call and submit it along with the current configuration to the FTP server with the instructions below?  Who is your SIP trunk provider?  Have you contacted them and had them enable a SIP trace for a failed call?

Open Internet Explorer web browser on their PC
Type the following URL:  ftp://ftp.adtran.com

Press the Alt key, click View, and then click Open FTP Site in Windows Explorer

Double-click the "Incoming" folder
Drag and drop files from PC into the Internet Explorer window

Reply to this post with the exact filenames used so we can retrieve the files

Thanks,

Matt

[Anonymous]

renaultl,

I also forgot to mention you should read our SIP Trunking guide first to make sure the unit is configured properly.  If everything looks right there and if the SIP trunk provider was not able to track down the issue, I would be happy to look at the debugs and configuration.

Thanks,

Matt

[renaultl]

thanks i will look at the guide, my trunk is registered and out going calls are working.

[jayh]

enable debug sip stack messages and debug voice verbose, preferably at a non-busy time. Place a call inbound to the unit and paste the output here. Typically this is due to a mismatch on the digits sent in the INVITE and the provisioned endpoint. If it is going to a PRI, the number of digits sent out the PRI trunk not matching what the PBX is expecting is the most common cause of this issue.