Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
godzillavstdm
New Contributor
‎03-11-2020 02:06 PM

Adran 924 - inbound calls on FXO ports produce glare

User has a 924, with a DID trunk on FXO ports.  Lines are used for inbound only, no outbound calls at all.

Approximately 20% of inbound calls fail, and the debug shows "glare", but since there are no outbound calls, both sides should not be seized at the same time.

His PBX is expecting wink start, which isn't an option from the Adtran on an FXO port, so we use DPT.

Is there another reason calls fail with with "glare" error?

0 Kudos
Reply
1 Reply
jayh
Honored Contributor
Honored Contributor
‎03-17-2020 06:21 PM

Re: Adran 924 - inbound calls on FXO ports produce glare

Probably because the PBX is expecting a wink. Can you option both the PBX and the TA900 for ground-start? This should virtually eliminate glare. You'll need to ensure that they share a common ground and that polarity is correct.

0 Kudos
Accept as Solution Reply