cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
New Contributor III

Can Adtran pass all dial plan to the PBX?

Jump to solution

I'm trying to understand why would I need another dial plan in the adtran when I already have it set up in my FreePBX?

How can I make it so my Adtran simply passes everything to the PBX? I don't need any more dial plans somewhere else.

0 Kudos
Reply
1 Solution

Accepted Solutions
Highlighted
New Contributor III

Re: Can Adtran pass all dial plan to the PBX?

Jump to solution

Solved the problem by removing ALL dial plans from the Adtran leaving only the $ cost 0.

View solution in original post

0 Kudos
Reply
4 Replies
Highlighted
Valued Contributor
Valued Contributor

Re: Can Adtran pass all dial plan to the PBX?

Jump to solution

The dial plan in the AOS is primarily only used when the ADTRAN is receiving the DTMF tones of the dialed number: like on an FXS port or an RBS T1. The dial plan is needed so the ADTRAN knows when the last digit is received and it can then process the call. Otherwise there is a default delay of 4 seconds while the ADTRAN waits to see if another digit will be dialed.

The dial plan isn't needed with SIP or PRI, only where the ADTRAN receives the DTMF digits for the number being dialed, and then has to determine if any more digits are expected. If there is no dial plan there will still only be a 4 second delay before a timeout and the call is processed.

Hope this helps,

Patrick

0 Kudos
Highlighted
New Contributor III

Re: Can Adtran pass all dial plan to the PBX?

Jump to solution

Hey Patric,

I was able to make Adtran pass all digits to the PBX with the 4 seconds delay, that's what I prefer.

I can finally dial all the feature codes of the PBX like voicemail, wake up calls, etc that didn't work before.

But when I dial a long distance number (my cell) it says The call cannot be completed as dialed.

That answer is by my PBX, as if not all digits of that number went through? My pbx is configured to accept the number. Long distance works great using an IP phone and an extension configured just like the Adtran extension. Why would PBX not pass through the Adtran long distance call?

0 Kudos
Highlighted
New Contributor III

Re: Can Adtran pass all dial plan to the PBX?

Jump to solution

Just following up on this issue. It seems like my Adtran won't accept any number longer than 3 digits.

I configured my trunk to pass all dial plan to the PBX by putting a $ in the field and clicking Add.

It passes all the 3 digit calls through, but not anything longer than 3 digits.

What should I change?

0 Kudos
Highlighted
New Contributor III

Re: Can Adtran pass all dial plan to the PBX?

Jump to solution

Solved the problem by removing ALL dial plans from the Adtran leaving only the $ cost 0.

View solution in original post

0 Kudos
Reply