Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
rnehrboss
New Contributor
‎02-21-2020 04:11 PM

Can I use Total Access 924e to route Dialogic T1 boards to SIP?

Hi,

I have dialers that use Dialogic boards that connect via T1s to our Telco.  I'd like to move to SIP trunking, but still use those dialogic cards.  Will the Total Access 924e take my dialogic t1's and route them to SIP over the Ethernet ports to our SIP provider?

Thanks!

Richard

0 Kudos
Reply
1 Reply
jayh
Honored Contributor
Honored Contributor
‎03-02-2020 02:02 PM

Re: Can I use Total Access 924e to route Dialogic T1 boards to SIP?

Yes, that is one of its most common uses. It can accommodate either T-1 robbed-bit CAS or PRI or a mix. The number of DSP resources is limited, so even though there are four T-1 interfaces on a 924e, it can only handle 60 simultaneous calls so figure a maximum of two voice T-1s per device.

0 Kudos
Accept as Solution Reply