DSP Failure

[smillstid]

I have an Adtran 904 2nd Gen.  Getting DSP message below.  Can this be corrected?

Current system image file is "T900G2A-R10-5-3-E.biz"

VoIP DSP 0 Initialize.

Loading Starcore DSP Image from Compressed File.

  Boot version: G2.R10.5.3

  Application Version: G2.R10.5.3

  Starting DSP.

  Booting.

  Memory Test.

  Failed to load application

DSP is not runningInitializing Analog Services.......

[jayh · Accepted solution]

In the rare cases where we've seen this, it has been a hardware failure requiring RMA of the unit.  You'll probably need to open a support case. 

Gotta love that long Adtran warranty! 

[smillstid]

Not the answer I was hoping for but appreciate the quick response.

[Anonymous]

Smillstid,

I'm going to mark Jayh's answer above as correct, since this is likely the issue.  If you need to setup an RMA with Adtran, please call 888-423-8726 to open a support ticket.

Thanks!

David

[sen-se]

Does anyone know where I can get the following firmware for an adtran 924 2nd gen.

T900G2A-R10-9-M-27-E.biz

[Anonymous]

Sen-se,

R10.9.M.27 is not a GA release of firmware. The next maintenance release of firmware that will contain fixes from R10.9.M.27 will be R10.9.2, which is scheduled to be available on January 3rd.

Thanks,

David

[cmaroon]

FOund the same issue after I upgraded from R7 to 13.12.1. 

VoIP DSP 0 Initialize.
Loading Starcore DSP Image from Compressed File.
Boot version: G2.R10.8.M.4b
Application Version: G2.R10.8.M.4b
Starting DSP.
Booting.
Memory Test.
DSP memory test failed.

Failed to load application

DSP is not runningInitializing Analog Services.......
SNMP Agent: Starting: Success!
FTP server: Starting service on first mounted drive.
cli: starting user interface
Persistence viewer: Restoring from startup-config..