cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
New Contributor II

Digit manipulation on Adtran 908e

Jump to solution

Hi All,

I am trying to make a  outgoing pstn calls from our Mitel PBX. I had created a sip trunk between our IP-PBX and Adtran. I had connected incoming pstn line to FXO port on Adtran. I want to send the incoming calls from our IP-PBX to the far end pstn user. Could you please provide me with the configuration  that I need to do in Adtran 908e.

Thanks in Advance...

0 Kudos
Reply
1 Solution

Accepted Solutions
Highlighted
New Contributor II

Re: Digit manipulation on Adtran 908e

Jump to solution

Hi Jayh,

Thanks for the reply

The below configuration worked for me. As mentioned the one in bold helped me do the trick.

voice trunk T02 type analog supervision loop-start

  description "FXO Trunk"

  caller-id

  trunk-number 613592

  connect fxo 0/0

match dnis "$" substitute "613287"

View solution in original post

0 Kudos
Reply
2 Replies
Highlighted
Honored Contributor
Honored Contributor

Re: Digit manipulation on Adtran 908e

Jump to solution

voice trunk T02 type analog supervision loop-start

no reject-external

connect fxo 0/0

voice grouped-trunk FXO-TG

  trunk T02

  accept NXX-XXXX cost 0

  accept 1-NXX-NXX-XXXX cost 0

  accept N11 cost 0

  accept 011$ cost 0

If your PBX sends calls in a format not acceptable to the carrier serving the FXO port, you can do match-substitute to tweak the digits to match, such as stripping a leading "9", adding a "1" for 10-digit numbers, etc. If the PBX presents calls in a manner that the carrier accepts the same way as a person with a conventional telephone would dial, then you're good.

To ring a particular PBX extension when the FXO line is dialed from outside, add something like the following line to the FXO ​voice trunk configuration. The example would ring extension 4444 on the PBX:

trunk-number 4444

0 Kudos
Reply
Highlighted
New Contributor II

Re: Digit manipulation on Adtran 908e

Jump to solution

Hi Jayh,

Thanks for the reply

The below configuration worked for me. As mentioned the one in bold helped me do the trick.

voice trunk T02 type analog supervision loop-start

  description "FXO Trunk"

  caller-id

  trunk-number 613592

  connect fxo 0/0

match dnis "$" substitute "613287"

View solution in original post

0 Kudos
Reply