cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable

Disable multilink ppp when T1 down

Jump to solution

How can I disable routing over a multilink ppp interface when one of the t1 links is down?

This would be a simple matter with a track on the route, but "test if interface" does not support t1.

The application is a TA908e with MLPPP over T1 for voice and backup WAN on eth 0/1. I want to avoid using the MLPPP interface when one of the member links is down, since it may not have sufficient bandwidth for the expected number of calls.

Labels (3)
0 Kudos
1 Solution

Accepted Solutions
jayh
Honored Contributor
Honored Contributor

Re: Disable multilink ppp when T1 down

Jump to solution

Stumped! I don't see a practical way to do this. Bandwidth changes but no way to track it.

Open a feature request to add T1 interfaces to those that can be tracked.

View solution in original post

0 Kudos
5 Replies
jayh
Honored Contributor
Honored Contributor

Re: Disable multilink ppp when T1 down

Jump to solution

Adtran has no configuration for the minimum number of links in an MLPPP bundle. Curiously, you can specify a maximum.

What's on the other end of the multilink PPP? If it's a Cisco, you can specify ppp multilink links minimum <number> on the Cisco side of the multilink interface. If a T-1 fails the line protocol will go down which will cause the TA908e to withdraw the route. 

Anonymous
Not applicable

Re: Disable multilink ppp when T1 down

Jump to solution

The other end is our provider. I still want the unit to be reachable via the ppp address, but not used as the default route.

jayh
Honored Contributor
Honored Contributor

Re: Disable multilink ppp when T1 down

Jump to solution

Stumped! I don't see a practical way to do this. Bandwidth changes but no way to track it.

Open a feature request to add T1 interfaces to those that can be tracked.

0 Kudos
Anonymous
Not applicable

Re: Disable multilink ppp when T1 down

Jump to solution

Unfortunately, the TotalAccess 900e series is not one of the products open for submitting feature requests directly, and I don't have direct address to an Adtran sales representative.

Submitting a Feature Request

Anonymous
Not applicable

Re: Disable multilink ppp when T1 down

Jump to solution

I will be out of the office and returning Friday February 24th. Please

call 207-326-2240 if you have an issue that needs immediate attention.

Thomas Lamontanaro

Network Support Specialist

207-326-2514

Maine Maritime Academy

* * * * * * * * * * * * * * *

This message, including any attachments, contains confidential information

intended for a specific individual

and purpose, and is protected by law. If you are not the intended

recipient, please contact the sender

immediately by reply e-mail and destroy all copies. You are hereby

notified that any disclosure, copying, or

distribution of this message, or the taking of any action based on it, by

anyone other than the intended

recipient, is strictly prohibited.