Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable
‎02-06-2017 05:08 PM

ISDN PRI w/ FXO Failover

Can the TA900 Series w/ FXO be used as failover for the ISDN PRI interface? We currently use a similar configuration w/ SIP Proxy but was wondering if the same applies for a traditional ISDN PRI interface. IE: We deliver SIP trunks to the Adtran then hand-off IDSN PRI to the customer. If the WAN connection goes down (SIP trunks) we want "at least" outbound emergency dialing and possibly a backdoor inbound route for incoming calls to the specific FXO number.

Labels (3)
0 Kudos
Reply
1 Reply
jayh
Honored Contributor
Honored Contributor
‎02-09-2017 05:31 PM

Re: ISDN PRI w/ FXO Failover

Yes. For outbound, configure the FXO voice grouped-trunk with the same patterns as the PRI but a higher cost.

For inbound, do the following:

On your FXO trunk add the line:

trunk-number 3015550110

where "3015550110" is the extension on the PBX of your auto-attendant or whatever destination you want FXO callers to reach. This should be whatever digit length you have in the accept pattern of the PBX's voice grouped-trunk. Ten digits for example here.

Note that inbound calls that ring the FXO will route to the PBX all the time, regardless of whether the PRI is up or down.

0 Kudos
Accept as Solution Reply