I am replacing a Cisco 891 with an Adtran 908e 3rd gen; the issue I am having is with setting up an inside to outside nat on the Adtran. Below is a sample config of what's programmed on the Cisco I need to do the same on the Adtran 908e 3rd gen. The respective LAN and WAN ports on the adtran will be eth0/1(WAN) and the eth0/2 (LAN) any help would be greatly appreciated. thank you!
CISCO CONFIGURATION
Interface FastEthernet 0
description LAN
ip address x.x.x.x 255.255.255.0
ip nat inside
ip virtual-reassembly in
Interface FastEthernet 1
description WAN
ip address x.x.x.x 255.255.255.248
ip nat outside
ip virtual-reassembly in
duplex full
speed 100
ip nat inside source route-map NAT interface FastEthernet1 overload
access-list 1 permit any
route-map NAT permit 10
match ip address 1
match interface FastEthernet1
