Total Access 900/900e Series

Forwarding originating caller ID and Redirecting Number Information Element (RNIE)

by on

0 Replies 5212 Views

How to keep NAT SIP Pinhole open

by on Latest post on by

1 Reply 5933 Views

Preventing SSH from timing out?

by on Latest post on by

5 Replies 6510 Views

* Code dial patterns in 908e

by on

0 Replies 3336 Views

ISDN switch-type for NI1

by on

0 Replies 2980 Views

924e gen3 caller id supported on fxo DID/DPT?

by on

0 Replies 3151 Views

Adtran 908e in stateful proxy mode for Wan failover

by on Latest post on by

3 Replies 3832 Views

Is there a way to get the carrier to limit the SIP connection to the 908e to match the number of B channels available?

by on Latest post on by

1 Reply 3191 Views

SIP msgPoolElements vs SIP proxyPoolElements

by on

0 Replies 2949 Views

Adtran P2P - Data/Voice configuration

by on Latest post on by

17 Replies 13722 Views

What is the Maximum number of SIP Trunks possible?

by on

0 Replies 2934 Views

Fractional PRI TA900

by on

0 Replies 2756 Views

Can You Programmatically Bridge Ports on Total Access 900 Series

by on

0 Replies 2695 Views

Issue when I reboot the PRI Dialogic Card - No channel available - 908e

by on Latest post on by

4 Replies 7125 Views

RTP Session allocated will not clear to available.

by on

0 Replies 2895 Views

Total Access 9XX - SIP to E&M Wink - ANI / DNIS format

by on Latest post on by

4 Replies 5186 Views

T38 FAX Codec

by on Latest post on by

2 Replies 5573 Views

How do i select <sip:541xxxxxxx@xxx.xxx.xxx.xxx> from a header into a HMR private-variable?

by on Latest post on by

1 Reply 4036 Views

Does the 924/924e provide options for far end CO answer supervision, or replicate it?

by on Latest post on by

1 Reply 3283 Views

Adtran 908e SIP to PRI

by on Latest post on by

2 Replies 4539 Views

Adtran 908e PRI B channels bouncing.

by on

0 Replies 3692 Views

PRI to Feature Group D Conversion

by on Latest post on by

3 Replies 4265 Views

SIP to Analog-DID ring-group

by on Latest post on by

2 Replies 4945 Views

T1 to SIP conversion

by on Latest post on by

9 Replies 11091 Views

908e SIP to PRI out of order packets

by on Latest post on by

2 Replies 6514 Views

TA904 with SIP and PRI working fine. FXS ports work for inbound but outbound routing to PRI instead of SIP

by on Latest post on by

3 Replies 6397 Views

TA 916e voice flashhook mode transparent not working

by on Latest post on by

6 Replies 6227 Views

TA904 as an ATA

by on

0 Replies 3512 Views

SIP Trunk via TA908e Adtran to NEC sv8100 - has anyone ever set this up successfully? I am having issues keeping the Outbound calls established.

by on Latest post on by

2 Replies 4610 Views

TA900 Rotary Phone / Pulse Dial Support?

by on Latest post on by

3 Replies 5399 Views

908e (2nd gen) loosing data connection

by on Latest post on by

8 Replies 7407 Views

Sip phones

by on Latest post on by

4 Replies 5366 Views

Debugging DTMF Sip -> PRI -> SIP

by on Latest post on by

3 Replies 6619 Views

Is there a doc available that would show me how to configure a 908e for a SIP to SIP trunk?

by on

0 Replies 3049 Views

Ping request

by on

0 Replies 3328 Views

Adtran TA 908e PRI hand off to Mitel 5000 getting message TM.T02 0 WARNING Trunk has no b-channels

by on

0 Replies 4257 Views

Config for HST-3000 testing

by on Latest post on by

7 Replies 5783 Views

After upgrading 904 from R10-9-0-E to R11-4-1-E There is a delay in speech path cut through from SIP to PRI calls. Reverting software clears the issue

by on

0 Replies 2904 Views

SIP to PRI- outbound call fails

by on Latest post on by

3 Replies 5810 Views

SIP extension outbound to FXO trunk

by on

0 Replies 3270 Views

I cant get SIP phones with private IP to work

by on Latest post on by

2 Replies 4824 Views

Retiring Cisco 891 with adtran 908e 3rd generation but need to configure basic inside to outside NAT

by on

0 Replies 3421 Views

Has anyone ever registered a FXS port to a Digium Switchvox. I can get it to register but I have to create allow statements in the Adtran 924-E . I would think since it registered to the Digium it would use the Call Managers dial plan.

by on Latest post on by

1 Reply 3374 Views

Call Coverage

by on Latest post on by

2 Replies 3877 Views

908e to NEC UX5000 cable pinouts

by on

0 Replies 3167 Views

I have trouble reading the barcode of the serial number with a scanner.

by on

0 Replies 3078 Views

TA908 PRI Error Code 57

by on Latest post on by

1 Reply 4447 Views

Need blown capacitor value for 908e

by on Latest post on by

5 Replies 5882 Views

FEATURE REQUEST - Probe with source-interface

by on Latest post on by

1 Reply 3811 Views

No audio out of analog phone. Am I missing something in config?

by on Latest post on by

6 Replies 5293 Views

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

SupportCommunity

Discussions

Support
Community