The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
stevemiller
New Contributor

TA-9XX 2nd Gen - PRI and SIP FXS Configuration

I'm looking for configuration guidance or best practices on configuration of the TA-9XX 2nd Gen devices for using SIP backhauled PRI and SIP FXS service on the same device. Customer has a PBX that will accept PRI and several additional devices that use POTS service.

I've been able to make this work, using a single configured voice trunk, but there seems to be a strange issue where calls from the PRI originated within the provider's network (I am the provider in this case) work fine, but calls outside the provider's network have no-way-audio. I can remove the FXS configurations or set up a second voice trunk and associate the FXS ports to that trunk, and the issue disappears.

My current configuration, redacted for security, is below.

Thanks in advance for any advice.

! ADTRAN, Inc. OS version R13.10.1.E
! Boot ROM version 14.04.00
! Platform: Total Access 908 (2nd Gen), part number 4212908L1
! Serial number [REDACTED]
!
!
hostname "LAB-TA908-1"
!
!
clock timezone [REDACTED]
!
ip subnet-zero
ip classless
ip routing
!
!
!
!
no auto-config
auto-config method https allow-sslv3
!
event-history on
no logging forwarding
no logging email
!
no service password-encryption
!
no ip firewall alg msn
no ip firewall alg mszone
no ip firewall alg h323
!
!no dot11ap access-point-control
!
interface eth 0/1
ip address dhcp hostname "Lab TA908"
no shutdown
media-gateway ip primary
!
interface t1 0/1
shutdown
!
interface t1 0/2
tdm-group 1 timeslots 1-24 speed 64
no shutdown
!
interface pri 1
connect t1 0/2 tdm-group 1
no shutdown
!
interface fxs 0/1
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
interface fxs 0/2
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
interface fxs 0/3
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
interface fxs 0/4
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
interface fxs 0/5
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
interface fxs 0/6
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
interface fxs 0/7
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
interface fxs 0/8
impedance 900c
rx-gain -6.0
tx-gain -3.0
battery-mode high
no shutdown
!
isdn-group 1
connect pri 1
!
ip access-list standard SIP-GLOBAL
![REDACTED]
!
ip route [REDACTED]
!
no tftp server
no tftp server overwrite
no http server
http secure-server
no snmp agent
no ip ftp server
ip scp server
no ip sntp server
!
sip
sip udp 5060
no sip tcp
!
voice feature-mode network
voice flashhook mode transparent
voice forward-mode network
!
voice codec-list "Default Codecs"
codec g711ulaw
codec g711alaw
!
voice trunk T01 type sip
description "SIP Trunk to Service Provider"
sip-server primary [REDACTED]
registrar primary [REDACTED]
registrar threshold percentage 75
max-number-calls 20
register [REDACTED] auth-name [REDACTED] password [REDACTED]
codec-list "Default Codecs" both
!
voice trunk T02 type isdn
resource-selection circular descending
connect isdn-group 1
rtp delay-mode adaptive
!
voice grouped-trunk "TRUNK GROUP"
description "Default Trunk Group"
trunk T01
accept $ cost 0
!
voice grouped-trunk PRI
trunk T02
accept $ cost 0
!
voice grouped-trunk 1
description "SIP to Service Provider"
trunk T01
accept $ cost 0
!
voice user [REDACTED]
connect fxs 0/1
no cos
password [REDACTED]
no call-waiting
block-caller-id
sip-identity [REDACTED] T01 register auth-name [REDACTED] password [REDACTED]
modem-passthrough
t38
t38 max-rate 9600
codec-list "Default Codecs"
!
voice mgcp-endpoint 1
block-caller-id
codec-group "Default Codecs"
connect fxs 0/4
modem-passthrough
t38
t38 max-rate 9600
!
ip mgcp
ip mgcp call-agent primary [REDACTED]
ip mgcp local-domain-name media-gateway
no voice fax-tone modem-passthrough t30-cng
voice fax-tone t38 t30-cng
!
sip access-class ip "SIP-GLOBAL" in
!
ip rtp quality-monitoring
ip rtp quality-monitoring sip
!
line con 0
no login
line-timeout 0
speed 115200
!
line telnet 0 4
login
shutdown
line ssh 0 4
login local-userlist
no shutdown
!
ntp source ethernet 0/1
ntp server [REDACTED] source ethernet 0/1 prefer
!
end

0 Kudos
1 Reply

Re: TA-9XX 2nd Gen - PRI and SIP FXS Configuration

 As it turns out, the no-way-audio issue was being caused by defective test gear. The TBERD 2310 I was using to perform test calls has an internal issue causing the one-way-audio.