BIG NEWS! The Adtran Support Community is moving! In the next few weeks it will be housed in a new location. Be sure to visit our NEW Adtran Community before the end of July to check it out and verify that you can access all the resources and features that you need. If you discover any issues with your account or access, or just want to let us know about your experience, be sure to use our Feedback Form to let us know!
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ftwrobert
New Contributor III

Total Access 9XX - SIP to E&M Wink - ANI / DNIS format

I'm looking for, and can not seem to find a way to change the format of the ANI and DNIS digits out to the PBX; We're looking to replace a customers (last mile) T1 based E&M with a SIP to T1 conversion on site.

Short of a direct answer, What's everyone experience of using the TA9XX units to provide E&M Wink services?

0 Kudos
4 Replies
jpruder
New Contributor

Re: Total Access 9XX - SIP to E&M Wink - ANI / DNIS format

Since you didn't provide what format you would like to see, The feature group D setting sends out *ANI*DNIS

ftwrobert
New Contributor III

Re: Total Access 9XX - SIP to E&M Wink - ANI / DNIS format

The particular format I'm trying to set is DNIS - But that's for this specific customer.

dmac
New Contributor III

Re: Total Access 9XX - SIP to E&M Wink - ANI / DNIS format

I use three TA908e's in my environment for the PRI interfaces. They are connected to 3 of our legacy PBX's so that we could use a centralized SIP Trunk. Was easy to setup/configure.  Not sure what you mean by "change the format" for the ANI and DNIS however in the Trunk Account in the GUI has options to change/substitute the ANI and DNIS and to change/substitute the ANI based on the DNIS of the call. The change is made on the outbound trunk from the 908 perspective. Als on our PRI's we only forward 4 digits which is set at the interface level of the PRI.

ftwrobert
New Contributor III

Re: Total Access 9XX - SIP to E&M Wink - ANI / DNIS format

I looked around the config to see where I would set a Feature Group but can't find it. What's the commands to do so?