cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
forced-inductn
New Contributor

Can't monitor ATLAS 890 with SNMP

Jump to solution

Hello,

I have inherited the task of maintaining an ATLAS 890. Awesome box, but I am still learning it. I am trying setup SNMP monitoring with little success.

SNMP is set to "Enabled" under SNMP > SNMP Access

Under SNMP communities, I have the IP address of the monitoring server and my community string. However when I try to snmpwalk the device I get the fallowing:

root@univac:~# snmpwalk -v2c -c <community> 10.1.0.4
Timeout: No Response from 10.1.0.4

If I do a port scan from the same host (that should be allowed to access SNMP) I get open/filtered:

Nmap scan report for 10.1.0.4

Host is up (0.023s latency).

Not shown: 995 closed ports

PORT     STATE         SERVICE

69/udp   open|filtered tftp

161/udp  open|filtered snmp

520/udp  open|filtered route

1718/udp open|filtered h225gatedisc

1719/udp open|filtered h323gatestat

Anything special I have to do?

Thanks!

--Forced

Tags (4)
0 Kudos
1 Solution

Accepted Solutions

Re: Can't monitor ATLAS 890 with SNMP

Jump to solution

Thanks patrick, I got it to work! I had to set snmpwalk to use snmp version 1. I swear I tried that last week, oh well

Thanks again,

--Will

View solution in original post

0 Kudos
2 Replies
Anonymous
Not applicable

Re: Can't monitor ATLAS 890 with SNMP

Jump to solution

Thank you for your question.

There isn't anything "special" that has to be configured in the ATLAS. The SNMP Access has to be ENABLED, and the SNMP COMMUNITIES has to be configured with the IP address, Priviledges, and community names for GET

and SET (read community and write community names) for the device trying to access the SNMP (or MIB walk).

Under SYSTEM CONFIG and EVENT LOGGING, you can set the SYSTEM CONTROLLER to INFO and then go to SYSTEM STATUS and view the EVENT LOG while doing the MIB walk. If there is an authentication error you will get an "SNMP Authentication Failure" event in the log. If there is an IP mismatch then no events will show in the log. (Also, if the MIB walk is successful, there are no events in the log.)

Hope this helps,

Patrick

Re: Can't monitor ATLAS 890 with SNMP

Jump to solution

Thanks patrick, I got it to work! I had to set snmpwalk to use snmp version 1. I swear I tried that last week, oh well

Thanks again,

--Will

0 Kudos