cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
drjarmon
New Contributor III

Event: config dynamicRF txpower

Trying to Track down source for this Event.  It appears the BG radio disabled due to a problem with Signal-to-Ratio (SNR) sum.  This indicates these is a Domain default setting for SNR that is being exceeded.


Timestamp: Thu, November 10, 2016 08:07:04 PM UTC
Event: config dynamicRF txpower
Source: bap
Message: Dynamic RF changed 00:00:00:00:00:00 radio BG txpower dBm to () as SNR sum was 107. Domain default
Hostname: Bluesocket
vWLAN MAC: 00:00:00:00:00:00


Thanks

Don Jarmon

0 Kudos
6 Replies
evanh
Contributor III
Contributor III

Re: Event: config dynamicRF txpower

Don,

What version of vWLAN is your system running?

Thanks,

Evan

ADTRAN Product Support Engineer

drjarmon
New Contributor III

Re: Event: config dynamicRF txpower

Product Name      :     BlueSecure AP/Sensor

Model Id          :     BSAP-2030

Hardware Id       :     2030-1010

Hardware Revision :     1

Software Version  :     2.6

Software Revision :     2

Software Build    :     7

evanh
Contributor III
Contributor III

Re: Event: config dynamicRF txpower

Don,

What setting do you have DynamicRF running in (shown in the AP template)? This message actually may just be missing the power setting as DynamicRF can't disable a radio. What power setting does that AP show on the 2.4Ghz radio?

Thanks,

Evan

ADTRAN Product Support Engineer

drjarmon
New Contributor III

Re: Event: config dynamicRF txpower

Continuous for both radios

evanh
Contributor III
Contributor III

Re: Event: config dynamicRF txpower

Don,

I have not seen that message before, but my guess is that it was a erroneous message as I have not seen that happen before (the message show a MAC address of all Zeros). We are actually about to release vWLAN 2.9.0 which changes quite a bit about DynamicRF including dramatically improving the channel selection algorithm. We also will now have Dual mode on all APs which allows continuous to make changes based upon other channels as well.

If you want to follow up on this message directly, I would suggest you open a ticket with us. You can go to www.adtran.com/openacase and follow the instructions. We may be able to look into the message and tell what happened.

Thanks,

Evan

ADTRAN Product Support Engineer

drjarmon
New Contributor III

Re: Event: config dynamicRF txpower

I zero'ed out the original MAC address: 00:19:92:4d:d6:c0.  The messages all include a valid MAC address of the troubled AP.